Audi-Resource

Removing and installing reversing camera -R189-

–	Switch off all electrical equipment.

–	Remove ignition key.

Removing

Reversing camera -R189- is equipped with a trailing cable. Vehicle wiring harness couplings are located on left side beneath tool kit.

–	Remove rear lid trim .

–	Unscrew bolt -1- (4 Nm).

–	Detach retaining plate -2-.

The reversing camera -R189--3- is secured to handle trim.

–	Pull reversing camera -R189--3- out of handle trim using a suitable tool.

–	Unplug connectors -1- and -2-.

Installing

–	Installation is performed in reverse sequence.

–	Close rear lid.

–	Perform calibration .